Old Garage Door Spring Adjustment

Start by removing the locking pin photo 1.

Old garage door spring adjustment.

The springs are located at the top inside part of the garage door. Then add or release tension until you get the proper close rate photo 2. Garage door springs offset the weight of the door and allow it to open and close with ease. Garage door springs are used to offset the weight of the door.

The other is attached to a pulley connected to the cable. Once the spring is free of tension remove from its track hanger. If the door was closing too quickly move the spring to the next higher hole on the bracket. Adjustment to torsion springs can be dangerous because they must be adjusted with the door down and the spring under tension.

One end of the spring is connected to the garage door track or frame. If the self closing door to your garage isn t closing hard enough to latch properly or the door slams shut you can adjust the spring hinge tension with a hex wrench and pliers. Adjusting garage door extension. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments.

Be sure to have all your tools inside before closing the door unless you have an alternate access door to the garage. This video applies t. Adjusting the tension or balance spring on an up and over garage door when the door feels heavy. There are two torsion springs at each side of the garage door.

Remove the locking pin. Adjust the spring into the proper position and make sure your garage door closes all of the way. Troubleshooting garage door springs. Adjusting garage door springs is a common repair.

Torsion springs must be adjusted with the door in the down position. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. Adjust the springs on both sides of the door the same way. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.

If it was opening too quickly move it to the next lower hole. When garage doors won t close all of the way or they close unevenly spring adjustment may be called for.